ROX 6.0 Page 22
Setting the total distance for bike 1 or bike 2
Basic settings
4.14.1 Displaying the intensity zones in normal mode
You can also obtain a graphical image of the area in which you are currently
training:
1 In normal mode, press
Mode 2
to switch to the intensity zones screen.
2 The four intensity zones are graphically displayed in the bottom display
segment.
3 An arrow shows you which zone you are currently training in.
4.15 Setting the total distance for bike 1 or bike 2
You can use this option to enter existing values (e.g. transferred from your old
device). New values are then added to these.
1 Press the
Mode 1
button to switch to the total distance for bike 1 or bike 2.
2 Press the
Set
button. The first digit for entry flashes.
3 Press
Mode 2
or
Reset
to increase or decrease the value respectively.
4 Press the
Mode 1
button to switch to the next digit.
5 Press the
Set
button to save your setting.
“Set OK” appears on the display.
Important Note:
00.080 mi is equivalent to 80 miles.
4.16 Setting the total trip time for bike 1 or bike 2
You can use this option to enter existing values (e.g. transferred from your old
device). New values are then added to these.
1 Press the
Mode 1
button to switch to the total trip time for bike 1 or bike 2.
2 Press the
Set
button. The first digit for entering the hours value flashes.
3 Press
Mode 2
or
Reset
to increase or decrease the value respectively.
4 Press the
Mode 1
button to switch to the next digit.
5 Press the
Set
button to save your setting. The minutes value flashes.
Mode 2Reset
Mode 1Set
Mode 2Reset
Mode 1Set
To Next Page
Loading...
