SL-50 SL-60 MIXERS
22 of 23
BLOCKAGE OF MACHINERY AND NECESSARY REMEDIES
OPERATION
ANOMALIES
POSSIBLE CAUSES REPAIR
Turning the master switch into
position, the warning light does
not turn on
1) Plug not inserted correctly or wires
detached.
1) Check connection.
Pressing the run button, the
mixer does not start.
1) The protection grid is open
2) Safety micro switches anomalies.
1) Rotate it and reposition it in
closed position.
2) Replace the micro switches.
Continuous noise.
1) Check the efficiency of the
bearings.
1) Replace the
bearings.
The tool does not perform its
normal revolution on the tool
holder shaft.
1) Loose belt.
2) Worn belt.
1) Tighten the belt.
2) Replace the belt.
To Next Page
Loading...
