SIGMA TANDEM SYSTEM OWNER’S MANUAL
Page 8:X
Section 2: Equipment • Chapter 3 - Packing the Reserve w/ Skyhook 11301 - 00.00.0000
Flake the material between the A and B lines
away from the line channel in the center of the
pack job. Be sure that all of the T-seams to the
outside of the center cell are neatly flaked. Find
the bottom seams to the outside of the center
cell and flake them out toward the stabilizer.
Make sure the B lines are grouped together and
stacked neatly on top of the A lines. Smooth
out the fold between the A and B lines.
Fold the flaked A to B material in half towards
the center of the pack job. Do not go beyond
the line attachment points.
Repeat the previous steps to flake the material
between the B and C lines. Continue flaking
process for the material between the C & D lines.
To Next Page
Loading...