C-DIAS PROCESSOR MODULE CCP 621
27.03.2020 Page 3
10 CAN Bus Termination ........................................................... 22
11 Wiring and Mounting Instructions ....................................... 23
11.1 Ground ......................................................................................... 23
11.2 Shielding ...................................................................................... 24
11.3 ESD Protection ............................................................................ 24
11.4 Mounting ...................................................................................... 25
12 Working With and On the CCP 621 ...................................... 25
13 Process Diagram ................................................................... 26
14 System Boot Checkpoints .................................................... 27
15 Status and Error Messages .................................................. 28
16 Application Exceptions ......................................................... 36
16.1 SRAM and IRQ routines ............................................................. 36
16.2 SRAM and Consistency of Changed Data ................................ 36
16.3 The File System Does Not Support Safe Writing via SRAM ... 36
16.4 Data Breakpoint .......................................................................... 36
17 Note on SRAM Behavior ....................................................... 37
18 Recommended Shielding for VARAN .................................. 38
18.1 Wiring from the Control Cabinet to an External VARAN
component ................................................................................... 39
18.2 Wiring Outside of the Control Cabinet ..................................... 40
To Next Page
Loading...
