Signature Hardware TOSCA

To Next Page

TOSCA THERMOSTATIC SHOWER SET INSTALLATION

GETTING STARTED

BEFORE YOU BEGIN

We recommend consulting a professional if you are

unfamiliar with installing plumbing ﬁxtures. Signature

Hardware accepts no liability for any damage to the

plumbing, ﬂoor, walls, tub, or for personal injury during

installation.

Observe all local plumbing and building codes.

Unpack and inspect the faucet for shipping damage. If

any damage is found, contact our Customer Relations

team at 1-866-855-2284.

Ensure that you have gathered all the required

materials that are needed for the installation.

For the following installation instructions, it is

assumed that the wall has been opened and that the

existing shower set has been removed.

Before you begin, the main water supply to your home

should be shut oﬀ.

TOOLS AND MATERIALS:

Plumbers

Tape

Adjustable

Wrench

Phillips

Screwdriver

1Tosca Thermostatic Shower Set Installation Instructions

Tape Measure

Drill

Hex Wrench

Wood Blocking

Soldering Kit

(for copper pipe)

½" Test Plug

Level

Pencil or

Marker

SKU(s): 925942

Need help?

Do you have a question about the Signature Hardware TOSCA and is the answer not in the manual?

Summary

Preparation and Tools

Before You Begin

Crucial preparatory advice and safety recommendations before installation.

Tools and Materials

List of necessary tools and materials for successful installation.

Getting Started

Initial steps and assumptions for commencing the installation process.

Step 1: Valve Installation

Valve Mounting and Preparation

Install wood blocking and secure the valve, ensuring correct orientation and level placement.

Piping and Connections

Route and connect in-wall piping, considering pipe type and fitting placement relative to the finished wall.

Step 2: Trim Installation

Wall Completion and Sleeve Removal

Complete wall construction, including finishes, and remove protective sleeves from valve stems.

Back Plate Installation

Slide the decorative back plate onto the valve, ensuring correct orientation of markings.

Control Knob Assembly

Disassemble, attach, and secure control knobs and levers to the valve spindles using provided hardware.

Shower Arm and Hose Connections

Install the hand shower's water supply elbow and shower head arm using thread sealant.

Final Assembly and Testing

Hand Shower Slide Bar Mounting

Determine location, mark, attach mounting brackets, and secure the slide bar to the wall.

Shower Head Attachment

Attach the shower head to the installed shower arm using thread sealant.

System Testing

Turn on the main water supply and test the shower system for leaks and proper function.