AFTER SALES SUPPORT
1300 7 77 137
service@unclebills.com.au
MODEL: EA2258 PRODUCT CODE: 709435 07/2022
18
2. Press down the OPEN button. The lens will display
the last mode selected when the Laser Range
Finder shutdown. Keep pressing the MODE button
till you reach the Fog Mode (see Fig. 6.1). Aim the
Laser Range Finder at your desired object. Press
and release the OPEN button (short press) until the
distance to the object is displayed on the lens (see
Fig. 6.2).
3. To ensure accuracy, hold the Laser Range Finder with
a rm grip and keep it steady till the measurement
is displayed.
4. The default unit of measurement is M (Metres). To
change the unit of measurement to Y (Yards), hold
down the MODE button. To switch between the two
units keep holding down the MODE button. Once
the unit of measurement desired is selected, release
the MODE button.
WARNING: Please always pass your hand through the
wrist strap prior to gripping the Laser Range Finder to
avoid it from dropping and getting damaged.
NOTE: Only use the Fog Mode in foggy conditions. If Fog Mode is used when
fog is not evident, inconsistent measurements will be recorded and displayed.
NOTE: Fog Mode is a stand-alone mode and cannot be used in conjunction
with any other modes of the Laser Range Finder.
NOTE: If no distance is displayed on the lens display, there is a possibility that
the object is not in the measuring range of 5 to 1000m. In this case, you will
need to retarget and measure.
NOTE: The Laser Range Finder will shut down automatically if it is not used
within 15 seconds of turning it ON.
INSTRUCTIONS (CONT.)
Fig. 6.2
Fig. 6.1
To Next Page
Loading...