AP05
Transport, Storage, Maintenance and Disposal English
AP05 · Date 25.09.2018 · Art. No. 88847 · Mod. status 316/18
34
7 Transport, Storage, Maintenance and Disposal
Transport and storage
Handle, transport and store position indicators with care. Pay attention to
the following points:
• Transport and / or store position indicators in the unopened original
packaging.
• Protect position indicators from harmful physical influences including
dust, heat and humidity.
• Do not damage connections through mechanical or thermal impact.
• Prior to installation inspect the position indicator for transport dam-
ages. Do not install damaged position indicators.
Maintenance
With correct installation according to chapter 4 the position indicator
requires no maintenance except for battery change to chapter 6 from time
to time. The position indicator has received lifetime lubrication and need
not be lubricated under normal operating conditions.
Disposal
The position indicator's electronic components contain materials that are
harmful for the environment and are carriers of recyclable materials at the
same time. Therefore, the position indicator must be recycled after it has
been taken out of operation ultimately. Observe the environment protec-
tion guidelines of your country.
Battery: Do no throw batteries in the normal waste, into fire or water. Col-
lect batteries and dispose of them in an environmentally friendly way.
Only for EU countries: Defective or used batteries must be recycled accord-
ing to Directive 91/157/EEC.
8 Accessory connector
(not included in the scope of delivery)
8.1 Mating connector M8 straight inclusive cable
• Accessory SIKO art. no. "KV04S1" (pin/female 4 pin bus IN/bus OUT).
To Next Page
Loading...
Need help?
General
