What to do if there is no water running down from the separator pipe in Silonn SLIM02?
If water isn't running down from the separator pipe in your Silonn Ice Maker, it may be because the holes are blocked. Try using a slim wire to prick each hole until water can flow out easily. Alternatively, the water filter might be blocked, so try cleaning it.
How to fix ice cubes that are too thick in Silonn SLIM02 Ice Maker?
If the ice cubes from your Silonn Ice Maker are too thick to drop down, the ice-making cycle might be too long. Try pressing “-” to reduce the ice-making cycle time.
What to do if the indicator light is on for Silonn SLIM02?
If the indicator light is on for the Silonn Ice Maker, it could be due to several reasons. First, check if there is a lack of water; if so, turn off the unit, add water to the level, and restart it. Another cause could be ice cubes overloading the basket, in which case you should remove some ice. It may also indicate a failure of the inlet solenoid valve or the ambient/water temperature sensor, for which you may need a technical service person or to change a new sensor.
Why are the ice cubes too thin in my Silonn SLIM02 Ice Maker?
If the ice cubes produced by your Silonn Ice Maker are too thin, it could be due to several reasons. The ambient temperature or the water temperature might be too high. Try moving the unit to a cooler place and ensure the water temperature does not exceed 25°C (77°F). Also, the ice-making cycle might be too short; in this case, press “+” to increase the ice-making time. If the ambient temperature is high or the water temperature is high, move the unit to somewhere where the ambient temperature is lower than 30°C (86°F), and fill it with cool water. In rare cases, refrigerant system leakage could be the cause, which would require assistance from a technical service person.
Instructions for cleaning the ice maker before its initial operation.
Procedures for cleaning the ice maker after extended periods of non-use.
Guidelines for storing the ice maker when not in use for extended periods.
Details the functions of the TIMER/CLEAN, ON/OFF, and adjustment buttons.
Explains the various symbols, codes, and indicators on the ice maker's display.
Steps for correctly positioning and preparing the ice maker before operation.
Detailed instructions on how to fill water and start the ice making process.
Instructions on adjusting the ice cube thickness.
Guide on how to initiate and cancel the self-cleaning program.
Instructions for setting the automatic on/off timer for the ice maker.
Procedures for draining water from the ice maker's tank and reservoir.
General| Model | SLIM02 |
|---|---|
| Weight | 17.6 lbs |
| Power Consumption | 120W |
| Voltage | 110-120V/60Hz |
| Material | Stainless Steel & ABS |
| Warranty | 1 year |
| Ice Production Capacity | 26 lbs per day |
| Ice Shape | Bullet |
| Water Reservoir Capacity | 2.2 liters |
| Ice Making Capacity | 26 lbs per day |
| Water Tank Capacity | 2.2 liters |
| Noise Level | ≤45 dB |
To Next Page
