20MulCenNX2.doc Page 3 Latest update: 24 Feb -03
• Do the re-assembling in reversed order of above instruction for dis-mantling
and not the following:
• Use an injector with silicone and place a thin string of silicon in the groove and
on the seats for the screws.
• Be careful with the threads when screwing the screws.
The 5 screws should be tighten with a torque of 1 Nm.
The PCB is replaced as a complete unit.
20.2 Spare Parts
21584 I-FRONT 67603 DISPLAY Compl. 67604 CPU PCB Compl.
67607 COVER Cartridge 67605 KEYBOARD Set 67606 Cable Internal
67609 CASING 21592 BRACKET for mont. 67608 SPACER Screw
21652-6 Cable, 6 m with connector. 21653 Connector CXA female 21587 Back Cover
20.3 MultiCenter software update instructions
To do the update a NavChart with a later software program is needed.
1. Turn MultiCenter off.
2. Insert the NavChart into MultiCenter’s chart slot.
3. Turn MultiCenter on.
4. Wait for the message ”UPGRADE CARTRIDGE FOUND”. On the screen
you can now verify that you have received the correct version.
5. Press the <ENTER> key to start the update or <CLR> to abort.
6. The MultiCenter will now start to beep, meaning it’s copying the NavChart
to it’s internal flash.
7. When the beep stops there will be a message ”UPDATE COMPLETED”.
8. Now you should remove the card
and hit <ENTER>. This will reboot
MultiCenter.
9. Congratulations! The upgrade is completed.
To Next Page
Loading...
Need help?
General