English - 23
10.4. Setting salt consumption
For good dishwashing results, the dishwasher needs low-lime water. Adding regeneration
salt helps to achieve the required water hardness with the aid of the softening system. To
maintain the function of the softening system, regeneration is performed regularly, resulting
in higher water and energy consumption during the process (see table below).
Set the required salt consumption, depending on the local water hardness.
The table below shows what setting is necessary for your local water hardness.
Ask your water utility about the water hardness.
Water hardness
Regeneration
at every X
program se-
quence*
Salt con-
sumption
P
must be
pressed
Display
LED ON/LED OFF
dH
(degree
of German
hardness)
mmol/l
(milli-
mole per
litre)
ECO
0–5 0–0.94 H1 – Press 1 x OFF OFF ON
6–11 1.0–2.0 H2 10 Press 2 x OFF ON OFF
12–17 2.1–3.0 H3 5 Press 3 x
(Factory set-
tings)
OFF ON ON
18–22 3.1–4.0 H4 3 Press 4 x ON OFF OFF
23–34 4.1–6.0 H5 2 Press 5 x ON OFF ON
35–55 6.1–9.8 H6 1 Press 6 x ON ON OFF
* When regeneration is carried out during a program, an additional 2.2l of water is required,
the energy consumption increases by 0.01kWh and the program is extended by 4 minutes.
Close the appliance door.
Press the button
(19)
to switch on the appliance and make settings.
Press and hold the P button (18) for approx. 5 seconds.
Then press the P button (18) several times in accordance with the table above to set the
salt consumption.
If you do no press any button within 5 seconds, the appliance switches to standby
mode.
To Next Page
Loading...
