English - 43
Unsatisfactory drying results
Fault Possible cause Solution
The dishes are not dried. The dishes were not
arranged correctly.
Arrange the dishes correctly
(see section “10.7. Arranging
the dishes and cutlery” on page
25).
Wear gloves if necessary if
detergent residues remain on
the dishes to avoid skin irrita-
tion.
The dishes were re-
moved too soon.
Do not remove the dishes im-
mediately after the program is
finished.
Open the door slightly so that
the steam can escape.
Remove the dishes while they
are still slightly warm.
An incorrect program
was selected.
The temperature is lower in
programs with a short runt-
ime. Select a program with
a longer runtime and higher
temperature.
17. Error messages
Potential error messages are indicated by flashing or illuminated operating lights. Errors
can be pinpointed and their causes determined.
If the error cannot be solved using the table, contact the service department.
Error message Problem Solution
Extra dry op-
erating light flash-
es
No water supply detect-
ed or water supply too
slow
Flow rate measurement, drain
valve or pump failure, contact the
service department.
The intensive pro-
gram
, ECO
and quick pro-
gram
oper-
ating lights are lit
up permanently
Too little water filled,
No water supply detect-
ed in the first three min-
utes
Fill up the water tank until an
acoustic signal sounds.
Then press the
button (14) to
start the appliance.
To Next Page
Loading...
