GB / MT 9
Connecting machine to power source
Attention:
Attention:
Sewing light
Foot control
Unplug power cord when machine is not
in use.
Consult a qualified electrician if in doubt
as to connect machine to power source.
Unplug power cord when machine is not
in use.
The foot controller (r) must be used with
the appliance by FC-2902B (220-240V
area)
Connect the machine to a power source as
illustrated.
Press main switch (A) for power and light
on. (" l ")
Foot controller (r) regulates the sewing
speed.
.
Installing the snap-in sewing table
Keep the snap-in sewing table horizontal,
and push it in the direction of the arrow.
The inside of the snap-in sewing table can
be utilized as an accessory box.
Getting ready
AA
To Next Page
Loading...
