18 GB
Adapters for Danfoss
Take care during installation that you do
not trap your fingers between the two halves
of the adapter!
One of the enclosed adapters is required for
installation on Danfoss valves. The arrangement
of the suitable adapter ring for the appropriate
valve can be found in the figures C–F.
The Danfoss valve bodies have elongated
indentations
13
running all around, which
also ensure better seating of the adapter
after it has been latched into place.
Note: When installing, please ensure that
the spigots inside the adapter
14
are in the
same position as the indentations
13
on the
valve.
Screw the adapter, which fits the valve,
onto the valve until it clicks into place.
91033_silv_Heizkoerperthermostat_Content_DK.indd 18 09.07.13 11:07
To Next Page
Loading...