- 16 -
What do I do if smoke comes from the baking space 0
or the ventilation slots 6?
• Remove the power plug immediately! Allow the appliance
to cool down, then remove the baking mould 4.
Clean the exterior of the baking mould 4 as well as
the baking space 0, as the smoke was probably cau-
sed by food residues. Should there be no food residues in
the baking space 0 or on the exterior surfaces of the
baking mould 4, do not switch the appliance back
on. Make contact with the Customer Service department.
What has happened if the ingredients are not correctly
mixed or the bread is not correctly baked through?
• A false programme has been selected.
• The button Stop/Start has been pressed during
operation.
• During the baking process there was an extended
power failure.
• The appliance lid 2 was opened several times during
the baking process.
• The kneading hook q is blocked.
Remove the ingredients and do not re-use them. Remove
the baking mould 4 and check to ensure that the drive
shaft 5 turns. Should this not be so, make contact with
our customer service department.
Why does the display 7 show „H:HH“ and the
appliance doesn't allow itself to be started?
• The appliance is still too hot from the previous baking
process. Press the button Stop/Start until the default
adjustments appear in the display 7. Leave the appliance
to cool down, with the lid 2 open, for approx. 20 minutes.
Afterwards, the appliance allows itself to be used as
normal.
To Previous Page
Loading...
