Silvercrest KH 2155 - Configuration Settings; Setting the Time

- 9 -
Conguration
Setting the time
The LCD display q shows you the time of day. You set this
as follows:
1.
Hold down the SET button e for a little longer than
3 seconds.
2. With the  or  button h select "CONFIG" and
conrmwiththeOKbuttonl.
3.
In the LCD display qappears"TIMESETUP".Conrm
with the OK button l. The LCD display qnow shows
"TIME"andtherstnumberofthehourdisplayblinks.
4. With  or  h place the cursor on the position, in
which you want to make an entry and press the number
buttons o to set the hour and minutes. The switching be-
tween AM and PM you undertake with the  or  but-
ton h. Thereby "AM" stands for "ante meridium"
(= morning, 0:00 to 12:00 o'clock) and "PM" stands for
"post meridium" (= afternoon, 12:00 to 0:00 o'clock).
5.
With the OK button l you save the setting. In the LCD
display q appears "SUCCESS" and the previous mode
is accessed again. In the event of an error the LCD
display q shows "ERROR".
6.
To exit this menu press repeatedly the EXIT button j
until the standard display appears in the LCD display q.
Adjust contrast
You can set the display's contrast as follows:
1.
Hold down the SET button e for a little longer than
3 seconds.
2. With the  or  button h select "CONFIG" and
conrmwiththeOKbuttonl.
3. With the  or  button h select "CONTRAST" and con-
rmwiththeOKbuttonl.
4. With the  or  h button you set the contrast (
reduces the contrast,  increases the contrast).
Display readout:
0 = highest contrast
15 = lowest contrast
5. With the OK button l you save the desired setting.
In the LCD display q appears "SUCCESS" followed
by "CONTRAST".
6.
To exit this menu press repeatedly the EXIT button j
until the standard display appears in the LCD display q.