- 26 -
The remote control does not change the station on the
device.
Press the corresponding device button
> r to set the remote
control to the correct mode.
In the event that the original RC does not have a "-/--"
>
button, change the programme with the CH+/— buttons y
or the number buttons.
If this also does not work the child protection for this
>
device could be activated.
Some of the remote control buttons do not function
properly.
It is possible that your universal remote control does not
>
have all of the functions that are on the device's original
remote control.
It is possible that you have not programmed in the optimal
>
code. Search for a code that supports more of the target
device's functions.
The remote control stops reacting after a button is
pressed.
The batteries must have enough voltage and be properly
>
installed.
Point the remote control towards your device.
>
The LCD display shows nothing.
The batteries must have enough voltage and be properly
>
installed.
The contrast could be set too low. Then increase the
>
contrast setting.
Disposal
Do not dispose of the device in your normal
domestic waste. This product is subject to the
European directive 2002/96/EC.
Universal remote control
Have the universal remote control or parts of it disposed •
of by a professional disposal company or by your com-
munal disposal facility.
Observe the currently applicable regulations. In case •
of doubt contact your disposal facility.
To Next Page
Loading...
