Silvercrest KH 2155 - Faults and Remedies; Remote Unresponsive or No Display; Incorrect Command Transmission

To Next Page

To Previous Page

- 25 -

Alternative button allocation in PIP mode

Note:

The PIP function (picture in picture) is only available in the

TV mode. Your TV device must support this function.

YouswitchthePIPfunctiononand/orowiththePIPbutton.

If the remote control is in the PIP mode the following buttons

serve as controllers for the PIP functions:

Button Normal function Function in PIP mode

move up in the

PIP +

move down in the

PIP —

switch to AV PIP source

move left in the

PIP size

move right in the

PIP position

Faults / Remedies

Your device does not react to the remote control.

Check the batteries. They must have enough voltage and

be properly installed.

Firstly have you pressed the correct device button

> r for

the desired target device?

Check to see that the correct code is programmed in for

the target device (see section "Programming the remote

control").

The remote control is transmitting the commands in-

correctly.

Press the corresponding device button to set the remote

control to the correct mode.

The batteries must have enough voltage and be properly

installed.

It is possible that you are using the wrong code. Start the

brand code search, the automatic code search or the

direct code input (manual).

Related product manuals