- 12 -
Radio functions
Selecting the band range
• Press the button BD/ENT (BAND/ENTER on the remote
control) to switch between USW (FM1, FM2,
FM3) and medium wave (MW1, MW2).
Automatic station search
• Press briefly the search buttons or to start
a search forwards/backwards. The search stops
at the next station found.
Manual station selection
• When you hold down one of the buttons or
for two seconds you switch to manual station
search. MANUAL appears in the display.
• Now press the search buttons or several
times to set the frequency in steps of 0.05 MHz
(MW: 9 kHz) up/down.
If no button is pressed for approx. two seconds the
automatic station search is set again. AUTO appears in
the display.
Programming stations
• Press the button BD/ENT (BAND/ENTER on the remote
control) to select a band range.
In each range you can save six stations.
• Search for the station that you want to save.
• After the search has found a station press one of
the station buttons 1-6 for approx. three seconds.
The brief switching off of the sound indicates that
the station is saved. In addition to the radio frequency,
the number of the memory position is also displayed.
The device switches back to radio playback after a
few seconds.
Accessing the station
• Select the band range with BD/ENT. (BAND/ENTER
on the remote control)
• By pressing one of the station buttons 1-6 you
access the saved station again.
Automatic saving
• Hold the A/PS button pressed. A search immediate-
ly starts in the currently set radio band. When the
search is completed, each of the identified stations
is played for roughly 1 second. The number blin-
king in the display indicates the number of the sta-
tion button to which the respective station is being
saved.
• To assign the station to a different memory posi-
tion, press the corresponding station button while
the identified station is being displayed.
Running through saved stations
You can access the saved stations of the current
station range.
• Press
BD/ENT to select the band range (BAND/ENTER
on the remote control).
• Press briefly the
A/PS button. All stations will be
briefly selected.
• When you hear the desired station press briefly
the
A/PS button.
Alternative Frequency (AF)
You can search for alternative frequencies of a station
so that it will always have optimal reception.
• Press the
AF button. The display shows AF. The
radio then always searches for the optimal radio
frequency of the selected station.
To Next Page
Loading...
