32 GB
Q
Setting up
Preparing the remote
control
Note: The button cell is already in the
battery compartment. Remove the con-
tract strips by opening the battery com-
partment as described below.
Replacing the battery
CAUTION! Danger of explosion
in the case of improper battery re-
placement. Only replace with the
same or equivalent battery type.
1. Open the battery compartment on
the back of the remote control by
turning the battery compartment
cover
4
anti-clockwise with the
aid of a coin or a screwdriver, then
removing the lid (open).
2.
Replace the button cell type CR
2032.
Make sure you fit the battery
with the correct polarity (+ = up).
3. Place the battery compartment
cover
4
back on and lock it in
place by turning it in a clockwise
direction (close).
4. Press one of the ON / OFF buttons
2
or
3
to test whether the remote
control works; if it does, the power
indicator light will come on
1
.
Q
Setting up the remote-
controlled socket
1. Plug the remote-controlled socket
into an earthed household socket.
2. The LED operating status display
5
will now flash slowly for approx.
30 seconds after plugging in.
3. Aim the remote control at the
remote-controlled socket at a
distance of approx. 50 cm.
4. With the LED operating status dis-
play
5
flashing, press the desired
ON button of the channel ON /OFF
button
2
(A, B, C or D) on the re-
mote control. The LED operating
status display
5
will now light
continuously. You can now use the
remote control to switch a con-
nected device on or off using.
5. Repeat this process with the other
wireless sockets.
Note: You can use one channel
ON / OFF button
2
to switch
several remote-controlled sockets
at once. You can further train six
remote controls successively and
use these for a single receiver. This
means you can switch one appliance
on and off from up to six different
places. In this case, synchronise
every remote-controlled socket with
the channel of the remote control.
Note: The codes for the remote
control will also remain stored
when changing the batteries.
Note: The codes will remain
permanently stored when discon-
necting the remote-controlled
socket from the power supply.
To Next Page
Loading...
