25 GB
Safety / Setting up
Do not switch the wireless sock-
ets erratically or unattended.
Q
Setting up
Q
Preparing the re-
mote control (fig. A)
1. Open the battery compartment
on the back of the remote con-
trol by turning the battery cover
to the left with a coin or a
screwdriver. Insert the button
cell. Ensure correct polarity
(+ = up).
2. Press one of the ON/OFF
buttons
2
or
3
to verify the
remote control is working; if so,
the operating control lamp
1
will light up.
Q
Setting up the remote
-
controlled socket
(fig. B)
1. Plug the wireless socket into an
earthed mains socket. You now
have 30 seconds to complete
steps 2 and 3.
Note: Always plug in the
wireless socket in the direction
indicated on the product label
to maintain the splash water pro-
tection (arrow
must point up).
2. Point the remote control at the
remote-controlled socket at a
distance of approx. 50 cm.
3. Push the respective ON button
of the Channel ON/OFF but-
ton
2
(A, B, C or D) on the
remote control. You can now
remotely switch a connected
device on or off. Once assigned
the process will complete.
To Next Page
Loading...
