15
Handling and use
SAR 28 A1
GB
IE
Further settings using the SEL button (EQ/LD/TA/AF)
♦ Hold down the SEL
18
button for about 2 seconds and then keep pressing
the SEL button until the required function is shown on the display.
♦ Turn the multi-controller
17
to change the settings of the menu item dis-
played.
TA - Enabling / disabling Traffi c Announcement (traffi c information)
TA ON: If TA mode is enabled, the device immediately switches from other sta-
tions or operating modes to the radio station that is currently transmitting traffi c
information.
NOTE
►
When the TA function is enabled, you can only search for or save stations
that are transmitting traffi c information. Stations that are transmitting traffi c
information signals are denoted in the display by TP.
TA OFF: The TA function is disabled.
AF - Enabling / disabling Alternative Frequencies
AF ON: When the AF function is enabled, the device searches for the current
station’s optimum frequency.
AF OFF: The AF function is disabled.
EQ - Equaliser
♦ Turn the multi-controller to select one of the FLAT, CLASSIC, ROCK, POP or
EQ OFF settings. No equaliser is enabled if EQ OFF is set. The equaliser
setting is shown at the bottom of the display.
SUBW - Subwoofer
You can connect an active external subwoofer to produce a more powerful bass
eff ect.
♦ Turn the multi-controller to enable the bass eff ect (SUBW ON) or disable it
(SUBW OFF).
AVOL - Set the volume when radio is switched on
♦ Turn the multi-controller to set the volume level used when the radio is turned on.
IB_85465_SAR28A1_LB3.indb 15IB_85465_SAR28A1_LB3.indb 15 06.12.12 16:4706.12.12 16:47
To Next Page
Loading...
