Silvercrest SAST 18 A1 - Before First Use

GB
│
IE
│
9 ■SAST 18 A1
Before first use
1) Remove all packaging materials from the appliance.
2) Check whether the filter holder
u and the HEPA filter z are firmly installed
in the dirt container
i. They may have worked loose during transport.
To insert the filter holder u and the HEPA filter z into the dirt container i,
proceed as follows:
– The filter holder u can only be fitted in the dirt container i in one
position. The side labelled “UP” must be facing upwards. Push the filter
holder
u as far as possible into the dirt container i. Make sure that
the filter holder
u is straight and that the rubber lip seals the dirt
container
i.
– Insert the HEPA filter
z into the filter holder u so that the catches on
the HEPA filter z fit into the corresponding recesses on the filter
holderu. The arrow on the HEPA filter z must be aligned with the
arrow on the filter holder u. Turn the HEPA filter z clockwise towards
the symbol.
3) Place the dirt container
i on the motor unit r:
– First, place the contacts on the underside of the dirt container
i onto
the contact pins on the underside of the motor unit
r. This pushes the
two catches on the motor unit
r into the recesses on the dirt
containeri.
– Press the upper side of the dirt container i against the upper side of
the motor unit
r so that the catch audibly engages. The dirt
container
i is now firmly seated on the motor unit r.