Silvercrest SAST 18 A1 User Manual

■ 16
│
GB
│
IE SAST 18 A1
Cleaning the brush attachment
To achieve the best results, the motorised brush attachment 6 should be
checked regularly for blockages and any hairs, threads or dirt should be
removed.
To simplify cleaning, the brush on the brush attachment
6 can be removed:
1) If you have not already done so, pull the brush attachment
6 out of the
suction opening.
2) Push the release switch on the brush attachment
6 in the direction of the
arrow (as far as the stop). The brush can now be removed and cleaned. The
release switch automatically springs back into place.
3) To replace the brush after cleaning, proceed as follows:
– Start by pushing one end of the brush onto the drive shaft on the
opposite side of the release switch. Note that only one side of the brush
fits onto the drive shaft.
– Push the release switch on the brush attachment
6 in the direction of
the arrow (as far as the stop) and hold it there. Now push the other end
of the brush into the appropriate recess on the side of the release switch.
– Let go of the release switch to lock the brush in place. The brush should
now be straight and firmly attached to the brush attachment
6.
Cleaning the appliance
1) Clean the housing and the attachments with a slightly damp cloth.
For stubborn soiling use a mild detergent on the cloth.
2) Dry all parts thoroughly before using the appliance again or storing it.
Storage
■ Place the appliance on the wall bracket 7 when you are not using it.
■ Store the accessories in the accessories holder
8.
■ Store the appliance in a dust-free and dry location.

Silvercrest SAST 18 A1 Specifications

General

Brand	Silvercrest
Model	SAST 18 A1
Category	Vacuum Cleaner
Language	English