Silvercrest SAST 18 A1 User Manual

GB
│
IE
│
11 ■SAST 18 A1
7) Place the barrel plug 9 of the power adapter 0 into the wall bracket 7
from below. Secure the barrel plug 9 by turning it.
8) Plug the mains adapter
0 into a power socket.
Charging
NOTE
► Check to ensure that the On/Off switch
q has been pushed back (to the
position "OFF") before starting the charging process.
■ Hang the appliance into the wall bracket
7 from above. The catches on the
wall bracket
7 should slide into the recesses on the motor unit r and the
barrel plug
9 into the socket on the lower end of the motor unit r. The
charge indicator lamp w flashes red and the charging process begins.
■ When charging is complete, which can take around 5 to 5.5 hours with fully
discharged batteries, the charge indicator lamp
w lights up green. The
appliance automatically switches to trickle charging. Nevertheless, in order
to avoid possible damage to the batteries, do not leave the appliance
permanently connected to the mains adapter
0.
■ Recharge the batteries again if the appliance’s suction power becomes
appreciably weaker and the charge indicator lamp
w flashes green.
NOTE
► If the charge indicator lamp
w flashes alternately green and red, the
battery is almost completely discharged and the appliance switches off
after approx. 1 minute. This protects the appliance from deep discharge.
► The appliance can also be charged directly via the mains adapter
0. To
do this, remove the barrel plug
9 from the wall holder 7 with a slight
twist and insert it into the socket on the appliance.
► The appliance cannot be operated during charging.

Silvercrest SAST 18 A1 Specifications

General

Brand	Silvercrest
Model	SAST 18 A1
Category	Vacuum Cleaner
Language	English