EasyManuals Logo

Silvercrest SAST 18 A1 User Manual

Silvercrest SAST 18 A1
244 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #18 background imageLoading...
Page #18 background image
GB
IE
 15 SAST 18 A1
Cleaning
ATTENTION! PROPERTY DAMAGE!
Do not use aggressive, chemical or abrasive cleaning agents. These could
damage the outer surfaces of the appliance.
Emptying the dirt container and cleaning the filter
NOTE
To achieve the best results, empty the dirt container
i and clean the HEPA
filter z regularly.
If you need a new HEPA filter
z, please contact our service department
(see section “Ordering spare parts”).
1) If you have not already done so, disconnect the appliance from the mains
adapter
0 or lift it off the wall bracket 7.
2) To open the dirt container
i, press the release button e and remove the
dirt container i from the appliance.
3) Remove the filter holder
u together with the HEPA filter z from the dirt
container i by pulling both straight out of the dirt container i.
4) Empty the dirt container
i.
5) Remove the HEPA filter
z from the filter holder u by turning it
anticlockwise towards the symbol and pulling it out.
6) Tap out the HEPA filter
z and the filter holder u over a rubbish bin. If
necessary, you can rinse out the filter holderu and the HEPA filter z with
fresh water. Before replacing the parts ensure that they are completely dry.
Do not dry the HEPA filter z with hot air.
7) Reinsert the filter holder
u into the dirt container i. Make sure that the
filter holder u is straight and that the rubber lip seals the dirt container i.
8) Insert the HEPA filter
z into the filter holder u so that the catches on the
HEPA filter z fit into the corresponding recesses on the filter holder u.
The arrow on the HEPA filter z must be aligned with the arrow on the filter
holder u. Turn the HEPA filter z clockwise towards the symbol.
9) Replace the dirt container
i on the motor unit r:
First, place the contacts on the underside of the dirt container i onto
the contact pins on the underside of the motor unit
r. This pushes the
two catches on the motor unit
r into the recesses on the dirt
containeri.
Press the upper side of the dirt container
i against the upper side of
the motor unit
r so that the catch audibly engages. The dirt
container
i is now firmly seated on the motor unit r.

Table of Contents

Other manuals for Silvercrest SAST 18 A1

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Silvercrest SAST 18 A1 and is the answer not in the manual?

Silvercrest SAST 18 A1 Specifications

General IconGeneral
BrandSilvercrest
ModelSAST 18 A1
CategoryVacuum Cleaner
LanguageEnglish

Related product manuals