11
SDBS2200A1
GB
IE
Disposal of packaging materials
The packaging protects the appliance from damage during carriage.
The packaging materials have been selected for their environmental friendliness
and ease of disposal, and are therefore recyclable.
Returning the packaging to the materials cycle conserves raw materials and
reduces the amount of waste that is generated. Dispose of packaging materials
that are no longer needed in accordance with applicable local regulations.
NOTE
► If possible, keep the original packaging of the appliance during the war-
ranty period so that the appliance can be packed properly for returning in
the event of a warranty claim.
Set-up location requirements
The surface on which you set up the base station must be stable, level and
heat resistant.
Electrical connection
♦ Plug the mains cable plug into a properly connected and earthed AC
power outlet which delivers the voltage given in the “Technical Data” section.
Handling and operation
This section provides you with important information on handling and using the
appliance.
Before initial use
♦ Clean the soleplate with a slightly damp cloth.
♦ To remove any production residues, iron several times over an old, clean cloth.
NOTE
The appliance is equipped with a safety valve which regulates the build-up of
excess pressure in the pressure vessel during the heating-up phase, and vents
excess steam through the steam outlets on the underside of the ironing station
This can lead to a slight escape of steam after switching on. This is normal
behaviour and lasts just a few seconds. It does not indicate a defect in the
steam iron station.
To Next Page
Loading...
Need help?
General
