Silvercrest SDBS 2200 A1 User Manual

17
SDBS2200A1
GB
IE
■ Use a funnel to add some water to the boiler and rinse it through several
times.
■ After you have emptied the boiler again, screw the Calc / Lock / Safe screw
cap
back into the thread and tighten it hand-tight.
Troubleshooting
This section contains important information on fault identifi cation and rectifi cation.
Observe the instructions in order to avoid risks and damage.
Safety guidelines
WARNING
Observe the following safety information to avoid risks and property damage:
► Repairs to electrical appliances should only be carried out by specialists
trained by the manufacturer. Improper repairs can cause considerable risks
to users and damage to the appliance.
Fault causes and rectifi cation
The following table will help to identify and rectify minor faults:
Fault Possible cause Remedy
The appliance is
not working.
Fault with the power supply.
Check whether the mains plug
is fi rmly in the socket.
The appliance is not switched on. Switch the appliance on using
the on/off switch
.
The appliance
produces no/too
little steam.
There is not enough water in the
water tank
.
Fill the water tank
with water.
The appliance is not suffi ciently
hot.
Wait until the "Steam ready"
indicator
lights up.
The steam control
is set to
minimum.
Turn the steam control
clockwise.

Silvercrest SDBS 2200 A1 Specifications

General

Brand	Silvercrest
Model	SDBS 2200 A1
Category	Iron
Language	English