Silvercrest SDMF 1300 A1 User Manual

■ 14
│
GB
│
IE
│
NI
│
CY
SDMF 1300 A1
Troubleshooting
This section contains important information on fault identification and
rectification. Follow the instructions to avoid hazards and damage.
Fault causes and remedies
The following table will help you to identify and rectify minor malfunctions. If the
solutions presented below do not resolve the problem, please contact the Service
Hotline.
Fault Cause Remedy
The appliance does
not emit steam.
The appliance is not
switched on.
Make sure that the appliance
is properly connected to the
power supply and press the
On/Off switch
. The blue
LED should flash during
the heating phase.
The water tank
 is
empty.
Switch the appliance off and
fill the water tank
.
The steam is used
up.
Allow the appliance to heat up
again.
The appliance emits
only a very small
amount of steam.
Limescale has
accumulated in the
appliance.
See section "Cleaning" –
Descaling.
The water tank
 is
empty.
Switch the appliance off and
fill the water tank
.
There is no steam
available yet.
The appliance does not start
producing steam until around
30 seconds after switching on.
The steam is almost
used up.
Allow the appliance to heat up
again.
The appliance takes
a long time to heat
up and/or white
particles are coming
out of it.
Limescale has
accumulated in the
appliance.
See section "Cleaning" –
Descaling.
Water drips from the
steam head
.
Limescale has
accumulated in the
appliance.
See section "Cleaning" –
Descaling.

Silvercrest SDMF 1300 A1 Specifications

General

Brand	Silvercrest
Model	SDMF 1300 A1
Category	Steam Cleaner
Language	English