8
GB
7. Switching on and off
Step-On function
If you would like to weigh the body weight
without diagnostic measurement, switch on
the scale using the Step-On function:
• Step on the measuring surfaces|1 of the
deactivated scale. After approx.
2 seconds, the scale is switched on
showing the weight.
Switching on for diagnostic
measurements
• Press the button surface SET|2. The
scale is switched on. The menu for the
profile settings is shown (see “Setting
the profile” on page 10).
Switching off automatically
The diagnostic scale switches off automati-
cally if there is no action for approx. 10 sec-
onds (setting, weighing, displaying).
8. Selecting the units of
measurement
You can select the unit of measurement in
which the diagnostic scale displays the
weight. Simultaneously, the unit of measure-
ment for the setting of the body height is ad-
justed.
NOTES:
• In the delivery condition and after the
battery change, the scale is set to kilo-
grammes (kg) and centimetres (cm).
• With the batteries|8 inserted (with suffi-
cient capacity) the setting remains
stored after the scale is switched off.
• The unit of measurement cannot be
changed if a weight or measured val-
ues are already displayed.
1. Switch on the diagnostic scale using the
button surface SET|2 and wait until
0.0 kg (0.0 lb / 0: 0.0 st:lb) is dis-
played.
2. Press several times the small button for
unit selection|5 on the underside of the
diagnostic scale to select between the
following units:
- kg kilogramme
(and cm: centimetre)
- lb pounds
(and ft: feet)
- st: lb stones, pounds
(and ft: feet)
NOTE: by pressing the button surface
SET|2 you access the menu for the profile
settings (see “Setting the profile” on
page 10).
BBB'LDJQRVHZDDJHB%ERRN6HLWH0LWWZRFK-DQXDU
To Next Page
Loading...
Need help?
General
