EasyManuals Logo

Silvercrest SEM 1100 D3 User Manual

Silvercrest SEM 1100 D3
78 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #17 background imageLoading...
Page #17 background image
14 
GB
IE
NI
CY
SEM 1100 D3
8) Slowly turn the steam control 7 in the direction “ “.
9) Move the frothing container around in a circular motion while keeping the tip
of the nozzle under the surface of the milk: deep enough that the milk does
not spray out, but shallow enough to create a thick froth. Done properly,
a deep buzzing sound is audible.
10) As the milk froth rises, push the nozzle deeper into the milk to froth up the
next “layer” and to avoid a burnt taste in the froth.
11) Finally, insert the nozzle completely and close the steam control 7 approxi-
mately halfway, so that the milk is heated. Hold the frothing container at a
slight angle, so that the milk gently swirls around while it is being stirred with
the nozzle.
12) Once the milk froth has reached the desired consistency and temperature,
turn the steam control 7 to off (up to the stop in the direction of the “
“).
13) Now you can remove the nozzle from the milk.
14) Proceed as described in the section “Cleaning the milk frother”.
NOTE
For cappuccino, always use bigger cups than for espresso because frothed
milk will be added.
15) To prepare cappuccino, proceed exactly as you would for espresso (see
section “Preparing espresso”; preheating is no longer necessary). Allow the
water to flow through for about twice as long as an espresso (about 40 ml).
NOTE
All of the control lamps may flash rapidly, if you press the “Espresso”
button
3 directly after preparing frothed milk. This means that the
appliance is too hot to prepare a perfect espresso. You can either continue
making an espresso anyway or allow the appliance to cool down.
As soon as the "Espresso" control lamp t lights up continuously, the
optimum temperature range for espresso has been reached again.
16) Switch the appliance off with the On/Off switch 1.
NOTE
If the “Espresso”
3 or “Steam” 4 buttons are not pressed for
about 30 minutes, the appliance switches off automatically.
17) Now add the frothed milk into the previously prepared espresso. The cap-
puccino is now ready. You can add sugar or sprinkle it with cocoa powder
according to taste.
NOTE
Always clean the milk frother 0 after every use. See also the section
"Cleaning and Care".

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Silvercrest SEM 1100 D3 and is the answer not in the manual?

Silvercrest SEM 1100 D3 Specifications

General IconGeneral
BrandSilvercrest
ModelSEM 1100 D3
CategoryCoffee Maker
LanguageEnglish

Related product manuals