■ 18
│
GB
│
IE
│
NI
│
CY
SEM 1100 D3
NOTE
►
The two espresso sieves o p, the measuring spoon a and the
drip tray q are dishwasher-safe.
Cleaning the appliance
Clean the appliance with a moist cloth. If necessary, use a little detergent on the cloth.
Ensure that the appliance is completely dry before the next use.
Descaling the appliance
CAUTION! PROPERTY DAMAGE!
► Do not generate steam when the descaler solution is in the water tank 9!
The machine has a descaling reminder function: after approx. 500 brewing
operations, the three control lamps 5 t z all flash rapidly 5 times at the same
time to remind you that the machine needs to be descaled. If you do not descale
the appliance immediately, the control lamps 5 t z will start flashing again
the next time you switch the appliance on. If you still have not descaled the appli-
ance after switching it on for the third time, the reminder function stops.
Proceed as follows to use the descaler s supplied with the appliance:
1) Add the descaler s (125 ml) to the water tank 9.
2) Fill the water tank 9 up to the Max mark with water and replace the tank
in the appliance.
3) Switch on the appliance using the On/Off switch 1. Make sure the steam
control 7 is shut off.
4) Insert the sieve holder i without any espresso sieve o p into the appliance.
5) Place 2 cups or a container capable of holding at least 250 ml under the
sieve holder openings.
6) As soon as the “Espresso” control lamp t lights up continuously, press the
“Espresso” button
3.
Allow around 250 ml (around 2 cups) of descaler solution to run through
and then stop the process by pressing the “Espresso” button
3 again.
Carefully pour out the used descaler solution.
7) Allow the descaler s to act for approx. 1 minute.
8) Repeat steps 6 to 7 three more times. Empty the water tank 9 completely
the last time.
9) Place a sufficiently large container (at least 1 litre) under the sieve holder
openings.
10) Rinse out the water tank 9 with fresh water and fill it with fresh water up to
the Max mark.