Silvercrest SFB 10.1 A1 - System Setup - Display Settings; Setting the Current Date; Adjusting LCD Contrast

- 14 -
2. With the  or  button t select "SYSTEM SETUP" and
conrm with the OK button l.
3. In the LCD display q "TIME SETUP" appears. Conrm
with the OK button l.
The LCD display q now shows
"TIME" and the time format (24 HR) blinks.
4.With the  or  button t you can switch to the other
time format (12 HR). After which the time display for the
time of day will show an “AM” or “PM” before the time.
„AM“ stands fpr “AM” = “ante meridium” (Morning, 0:00
o’clock midnight to 12:00 o’clock midday). „PM“ stands
for “PM” = “post meridium” (Afternoon and evening,
12:00 o’clock midday to 0:00 o’clock midnight). Press
the OK button l to conrm.
5.Now the hour indicator blinks. With the  or  button t
select the hour number for the present time of day and
press the OK button l.
6.Now the minute indicator blinks. With the  or  button
t select the minute number for the present time of day
and press the OK button l to save. The "TIME SETUP"
notice appears again.
7. To exit this or the following menus press repeatedly the
EXIT button y until the standard display appears in the
LCD display q.
Setting the date
The LCD display q shows you the date when you press the S
button r. You set the date in this way:
1. Hold down the S button r for a little longer than 3 sec-
onds. The notice "CODE SETUP" appears.
2.With the  or  button t select "SYSTEM SETUP" and
conrm with the OK button l.
3. In the LCD display q "TIME SETUP" appears. Press the 
button t to change to "DATE SETUP". Conrm with the
OK button l.
4.In the display the year "2011" blinks. With the  or
 button t you can change the year and conrm with
the OK button l. With the  or  button t you can
change the now blinking month and conrm with the OK
button l. Now the day indicator blinks which you can
also change with the  or
 button t.
5. To save press the OK button l. The "DATE SETUP"
notice appears again.
Adjust contrast
You can set the display's contrast as follows:
1. Hold down the S button r for a little longer than 3 sec-
onds. The notice "CODE SETUP" appears.
2.With the  or  button t select "SYSTEM SETUP" and
conrm with the OK button l.
3.With the  or  button t select "CONTRAST SETUP"
and conrm with the OK button l.
BDA_SFB 10.1 A1 - DT-62327_gb.indd 14 19.04.2011 15:01:58