Silvercrest SFB 10.1 A1 - Select a Tape-;Disc Device for Direct Operation; Setting the Lock Function

- 16 -
1. For this purpose select in the VOL/MUTE SETUP with the
 or  button t the function MODE VOL SET and
confirm with the OK button l.
2.Now press the device button e for the device that is to
be excluded from the global volume control. The LCD
display q shows „SUCCESS“ and the global volume
control is deactivated if the URC is working in the opera-
tional mode of one of the selected devices.
You can also cancel the settings again in VOL/MUTE SETUP.
1. For this purpose select in the VOL/MUTE SETUP with the
 or  button t the function VOL/MUTE RESET and
confirm with the OK button l.
2.The LCD display q prompts you, with CONFIRM RESET,
to a confirmation which is done by pressing the OK but-
ton l. Press the OK button
lIf you want to delete the
settings, the SUCCESS indicator then confirms the dele-
tion. Otherwise you press the EXIT button
yto abort the
deletion.
Select a Tape-/Disc device for direct operation
You can select a tape or disk device that you can control
with the playback buttons f without rst having to press the
corresponding device button e.
1. Hold down the S button r for a little longer than 3 sec-
onds. The notice “CODE SETUP” appears.
2. With the  or  button t select “SYSTEM SETUP” and
conrm it with the OK button l.
3. In the LCD display q “TIME SETUP” appears. Press the
 button t to switch to “PLAYBACK SETUP”. Conrm
with the OK button l.
4. With the  or  buttons t now select the device that
should respond to the URC when you use the playback
buttons f. Conrm with the OK button l.
5. If instead of a device you select “OFF” and conrm it with
the OK button l, you switch the direct operation o. If
you select “RESET”and conrm it with the OK button l,
you activate the pre-programmed factory settings for this
function.
6. The LCD display q shows “SUCCESS” and the selected
device can now be directly controlled using the playback
buttons f.
Setting the lock function
With the lock function you can block access to all setup menus.
1. Hold down the S button r for a little longer than 3 sec-
onds.
2. With the  or  button t select „SYSTEM SETUP“ and
confirm with the OK button l.
3.With the  or  button t select “LOCK SETUP and
confirm with the OK button l. The LCD display q shows
the current settings.
BDA_SFB 10.1 A1 - DT-62327_gb.indd 16 19.04.2011 15:01:58