Silvercrest SFB 10.1 A1 User Manual

- 20 -
Note:
Should the notice not change to "LEARNING" you have
selected a button for which no button code can be
taught.
6. Point the infrared sensors 2) of both remote controls
towards each other.
7. Now hold down the desired button of the original
remote control until "SUCCESS" or "LEARN ERROR"
appears in the display q of the URC.
8. If in the LCD display q "SUCCESS" appears (process
successful), you can teach further buttons begining with
step 5. If "LEARN ERROR" appears (process unsuccessful)
repeat the process in any case from step 5.
9. To cancel/terminate the learning process, during the
display “LEARN SET”, repeatedly the EXIT button y until
the standard display is show in the LCD display q. Dur-
ing the notice "LEARN KEY" and/or "LEARNING" simply
allow 30 seconds to pass without any operation then the
device will end the menu.
Delete all programmed buttons of all devices
1. Hold down the S button r for a little longer than 3 sec-
onds. The notice "CODE SETUP" appears.
2.With the  or  button t select the menu "LEARN
SETUP" and then press the OK button l. In the LCD
display q "LEARN SET" appears.
3.With the  or  button t select "LEARN CLEAR"
(taught delete) and conrm with the OK button l. In
the LCD display q "CONFIRM CLEAR" (conrm delete)
appears.
4. Conrm with the OK button l.
In the LCD display q
"SUCCESS" appears. All programmed buttons are de-
leted. Finally the menu will automatically end.
 Note:
When the LCD display shows “CONFIRM CLEAR” you can
stop the deletion with the EXIT button y.
MacroSetup
With the MACRO function up to 16 button commands can
be carried out with the press of a single button, that is to say,
several previously saved control commands can be deleted
with one MACRO button. There are 6 Macro memory slots
available for you.
To programme a Macro
For Macro programming proceed as follows:
1. Hold down the S button r for a little longer than 3 sec-
onds. The notice "CODE SETUP" appears.
2.With the  or  button t select "MACRO SETUP" and
conrm with the OK button l. In the display "MACRO
SETUP 1" appears.
BDA_SFB 10.1 A1 - DT-62327_gb.indd 20 19.04.2011 15:01:58

Silvercrest SFB 10.1 A1 Specifications

General

Brand	Silvercrest
Model	SFB 10.1 A1
Category	Remote Control
Language	English