Silvercrest SFE450A1-05/10-V2 User Manual

11
GB
6. If you want to drain into the water tank 5
again, switch off the device. Pull off the
hose
24 or unscrew the garden hose and
adapter
25 . Insert the plug 22 tightly
again into the opening.
9. Cleaning and
replacing the filter
The performance of the device also depends
on the cleanliness of the filter.
•The carbon filter 30 should be cleaned
every 2 weeks and replaced every
6months. Clean the filter by brushing
or vacuum suction.
• The normal plastic filter 29 should be
washed every 2 weeks.
1. Switch the device off and pull out the
mains plug
11 .
2.
Figure F: pull the grid 8 away from the
device using the handle and remove it
downwards.
3. Turn the grid
8 around. Insert one finger
into the recess on the plastic filter
29 and
pull it upwards to remove it.
4. Remove the carbon filter
30 and clean it.
(The carbon filter
30 should be replaced
after approx. 6 months.)
5. Wash the plastic filter
29 with lukewarm
water.
6. Let the plastic filter
29 dry completely.
7. Place the filters into the grid
8 .
8. Place the grid
8 onto the device. Press the
grid down all around to ensure that it clos-
es flush with the surface.
NOTE: new carbon filters are available in
almost all household goods shops. The pads
just need to be cut to size.
10. Cleaning
Clean the device prior to its first use!
DANGER! Risk of electric
shock!
~ Pull the mains plug 11 out of the
grounded power socket before you
clean the device.
~ The device, the power cable and the
mains plug 11 must not be immersed in
water or any other liquids.
WARNING! Risk of material dam-
age!
~ Do not use any astringent or abrasive
cleaning agents.
• Wipe the housing and the power ca-
ble11 with a damp cloth if necessary.
• Remove the water tank 5, pour out the
water, and dry the tank well from the
outside before re-inserting it into the de-
vice.
Cleaning the water tank
We recommend cleaning and disinfecting
the water tank approximately every two
weeks in order to prevent the formation of
moulds and bacteria.
1. Figure E: fold the handle of the water
tank
27 in such a way that you can press
it out of the attachments on the sides. Re-
move the handle.
2. Take out the lid of the water tank
28 .
3. Clean the inside of the water tank
5 with
lukewarm water and mild detergent and
rinse out several times with fresh water.
4. For the purposes of disinfection, use a
commercially available disinfectant on an
alcohol base or high-percentage alcohol.
Then rinse thoroughly with clean water.
5. If you are not going to use the device for
an extended period of time, dry the inside
of the water tank
5 completely.
6. Put the lid
28 and the handle 27 back in
place.
7. Put the water tank
5 back into the device.
__CPE111670_B6.book Seite 11 Mittwoch, 11. März 2015 12:51 12

Silvercrest SFE450A1-05/10-V2 Specifications

General

Brand	Silvercrest
Model	SFE450A1-05/10-V2
Category	Dehumidifier
Language	English