EasyManua.ls Logo

Silvercrest SGW 860 A1 - General Faults and Solutions; Noise-Related Troubleshooting

Silvercrest SGW 860 A1
411 pages
Go to English
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
English -87
General faults
Fault Possible cause Solution
Blotched ap-
pliance acces-
sories
Detergent with colour ad-
ditives was used.
Only use detergent without colour
additives.
White deposits
inside the appli-
ance
Mains water hard/high in
calcium carbonate
Clean the appliance with a lit-
tle cleaner for dishwashers us-
ing a damp sponge. Wear rubber
gloves during cleaning.
Always use only cleaners for
household dishwashers.
Rust marks on
the cutlery
The cutlery in question is
not stainless
Use only dishwasher-safe cutlery.
No program was started
after adding salt.
Always start the Quick program
without dishes after adding salt.
Noise
Fault Possible cause Solution
Knocking/rat-
tling noise in
the appliance.
The spray arm (4) knocks
against the dishes and/or
against an item in the dish
rack (7) or one of the dish-
es is loose in the rack.
Stop the program and rearrange
the dishes.
Knocking noise
in the
water pipes.
Noise may be due to
on-site installation
or water pipes crossing.
The knocking noise does not af-
fect the performance of the dish-
washer.
In case of doubt, contact a quali-
fied plumber.

Table of Contents

Other manuals for Silvercrest SGW 860 A1