EasyManua.ls Logo

Silvercrest SHAZ 21.6 B2 - Items Supplied

Silvercrest SHAZ 21.6 B2
39 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
6
GB
take the device out of the water. Do not
use the device again, and have it
checked by a specialist workshop.
~ Never touch the device with wet hands.
DANGER! Risk of electric shock
~ Lay the power cable such that no one
can step on it, get caught on it, or trip
over it.
~ Only connect the power adapter to a
properly installed and easily accessible
wall socket whose voltage corresponds
to the specifications on the rating plate.
The wall socket must continue to be eas-
ily accessible after the device is
plugged in.
~
Ensure that the power cable cannot be
damaged by sharp edges or hot points.
Do not wrap the power cable around the
device (Danger! Risk of cable damage!).
~ Ensure that the power cable cannot be
trapped or crushed.
~ To pull the power adapter out of the
wall socket, always pull on the power
adapter, and never on the power cable.
~ Disconnect the power adapter from the
wall socket …
if there is a fault,
as long as you do not charge the bat-
tery,
prior to cleaning the base station,
and
during thunderstorms.
~ If the power cable or the device (base
station) is damaged, immediately pull
the power adapter out of the wall sock-
et.
DANGER - Danger of
explosion
~ Never throw the battery into open fire.
WARNING! Risk of material damage
~ Fasten the base station firmly to the wall.
Check whether the enclosed fixing materi-
al is suitable. If necessary, use other
screws and rawlplugs. If in doubt, have
the assembly performed by an expert.
~ Before drilling, check that there are no wa-
ter pipes or power cables in the wall at the
relevant point.
~ Only use the rechargeable vacuum cleaner
with all filters installed. Vacuuming without
the filters installed destroys the motor.
~ Never come close to hair or loose clothing
with the rotating brush.
~ Use the original accessories only.
~ Do not use any sharp or abrasive cleaning
agents.
NOTES on the battery
Only use the original battery charger (base
station) to load the batteries.
The battery becomes warm during the
charging process. This is normal.
4. Items supplied
1 suction device|5 with dust container|11
1 base station|26
1 power adapter|31
1 battery|33
1 suction pipe|20|
1 floorhead|22
1 small brush nozzle|36
1 large brush nozzle (rotatable)|37
1 large nozzle|38
1 adapter|39 for the small brush nozzle
and small nozzles|
1 adapter|40 for the large brush nozzle
1 drilling template
1 set of fixing material (2 rawlplugs, 2
screws)
1 copy of the user instructions

Related product manuals