12
GB
9.2 Metal filter
The metal filter|11 is lo-
cated at the end of the
filter carrier|7. With a
slight twist, the metal fil-
ter|11 can be released
and put on again.
• To release, rotate the metal filter|11 in
the direction of the open lock symbol
.
• When assembling, rotate the metal fil-
ter|11 in the direction of the closed lock
symbol . Ensure that the metal filter|11
clicks firmly into place.
9.3 Paper filter (HEPA)
The paper filter|6 is located at the upper end
of the filter carrier|7.
• Release the paper filter|6 with a slight
twist before pulling it off.
•When inserting the
filter, ensure the posi-
tion of the small later-
al pins at the paper
filter|6. They must fit
into the openings of
the filter carrier|7.
Then, lock the paper
filter|6 again.
9.4 Motor protection filter
Between the dust con-
tainer|10 and the suc-
tion device|5 the motor
protection filter|12 is lo-
cated.
• Remove the dust con-
tainer|10 from the
suction device|5.
Then, you can re-
move the motor pro-
tection filter|12 from
the inside of the suc-
tion device|5.
9.5 Exhaust air filter
There are two exhaust
air filters|2 at the sides
of the suction device|5.
• To remove the filters,
press the unlocking
mechanism|3 at the
filter cover|4. Then,
you can remove the
exhaust air filter|2
from the filter cov-
er|4.
To Next Page
Loading...
