SIKL 40 A1
■ 18
│
GB
│
IE
Pairing/unpairing headphones with a Bluetooth
®
playback device (without speaker box)
Note
► You can also pair the headphones
1
with a compatible
Bluetooth
®
playback device independently of the speaker box
6
.
The speaker box
6
does not have to be switched on for this.
♦ Remove the two headphones
1
from the speaker box
6
.
The LED indicator
3
of the left headphone
1
flashes red and
white alternately. The LED indicator
3
of the right headphone
1
flashes white once at intervals of approx. 5 seconds. The head-
phones
1
are now in pairing mode.
♦ Select the entry SIKL 40 A1 from the list of found devices of your
Bluetooth
®
playback device to connect the two headphones
1 to the playback device. If pairing is successful, a tone se-
quence will sound and the
LED indicator
3 of both headphones
1
will flash white once at intervals of approximately
5 seconds.
♦ To disconnect the Bluetooth
®
connection, either disable the
Bluetooth
®
function on the Bluetooth
®
playback device or
press and hold the multi-function button 2 of one headphone 1
for approx. 4 seconds to switch off the headphones 1.
♦ Alternatively, place the headphones
1 back into the switched-off
speaker box 6, to disable the Bluetooth
®
function.
To Next Page
Loading...
