Silvercrest SKBA 2 A1 User Manual

SKBA 2 A1
GB
│
IE
│
NI
│
9 ■
NOTE
► After you have successfully paired the headphones with a Bluetooth
®
playback device, they will automatically try to connect to this device
the next time you switch them on. Automatic reconnection only works
if you have not terminated the Bluetooth
®
connection of the devices
manually beforehand.
► Ensure that the headphones are no more than 10 metres away from the
Bluetooth
®
playback device. Make sure that there are no barriers or
electronic devices placed between them.
► If no connection can be made within 10 minutes, pairing mode ends
and the headphones switch off.
♦ To terminate the Bluetooth
®
connection, either disable the
Bluetooth
®
function on the Bluetooth
®
playback device or hold
down the PAIRING button 4 for approximately 2 seconds until you hear
a rising series of beeps, and the operating/charging LED 0 flashes red
and blue. The headphones will return to pairing mode.
♦ Switch the headphones off to deactivate the Bluetooth
®
. To switch
off the headphones, press and hold the
button 5 until you hear
a rising series of beeps and the operating/charging LED 0
goes out.
Controlling music playback
The following music playback functions are only available when the head-
phones and the playback device are connected via Bluetooth
®
.
Some smartphones, music apps or music players may not support all
functions.
Button Function
5
► Press briefly to play/pause the music.
7
► Press briefly to increase the volume. When you
reach the maximum volume you will hear a
beep.
► Press and hold to jump to the next track.
8
► Press briefly to decrease the volume.
► Press and hold to jump back to start of the track.
Press and hold again within 2 seconds to jump
to the previous track.

Silvercrest SKBA 2 A1 Specifications

General

Brand	Silvercrest
Model	SKBA 2 A1
Category	Headphone
Language	English