SKBA 2 A1
■ 8
│
GB
│
IE
│
NI
NOTE
► The operating/charging LED 0 lights up orange during charging.
When the battery is fully charged, the operating/charging LED switches
off.
► Charging takes about 3.5 hours at a charging current of 500 mA.
When the battery is fully charged, you can play back music for about
20 hours at a medium volume in headphone mode or for up to 5 hours
in speaker mode. The playback time may vary depending on usage
(volume).
► When the battery is empty, you will hear two beeps at an interval of
two minutes, and the operating/charging LED 0 flashes three times or-
ange every 15 seconds. The headphones then switch off automatically.
Wearing the headphones
♦ When putting the headphones on, please note the side markings “R”
(right) and “L” (left) on the inside of the head band 1.
♦ Adjust the headband 1 so that it fits your head comfortably and the
earpieces e + r cover your ears.
Pairing the headphones with a Bluetooth
®
device
Before you can use the headphones with the Bluetooth
®
function, you
must pair it with a compatible Bluetooth
®
device.
♦ To switch on the headphones, press and hold the
button 5
until you hear a rising series of beeps and the operating/charging LED
0 lights up violet for 2 seconds. Afterwards, the operating/charging LED
flashes blue once every 3 seconds.
♦ Press and hold the PAIRING button4 until the operating/charging LED
0 flashes alternately orange and blue to activate pairing mode.
♦ Set the Bluetooth
®
playback device so that it scans for Bluetooth
®
devices. A detailed description of how to do this can be found in the oper-
ating manual for your Bluetooth
®
playback device.
♦ Select the entry SKBA 2 A1 from the list of found devices on your
Bluetooth
®
playback device and, if required, enter the code 0000
to connect the two devices. If the pairing is successful, you will hear
a rising series of beeps and the operating/charging LED 0 flashes
blue twice at 3-second intervals.
To Next Page
Loading...
Need help?
General
