Silvercrest SKBA 2 A1 User Manual

SKBA 2 A1
■ 12
│
GB
│
IE
│
NI
Cleaning
CAUTION
► Do not allow any liquids to penetrate interior of the headphones. This
could cause irreparable damage to them.
► Do not use aggressive or abrasive cleaning agents, as these can
damage the device surfaces.
♦ Clean the outer surfaces of the headphones with a slightly damp cloth.
Storage when not in use
♦ Store the headphones in a dry environment.
♦ To ensure a long battery life, charge the battery at regular intervals.
Troubleshooting
Fault causes and remedies
The following table will help you to identify and rectify minor malfunctions:
Fault Possible cause Remedy
Headphones
does not switch
on.
The integrated battery is
not charged.
Charge the battery (see sec-
tion Charging the battery).
The
Bluetooth
®
connection
cannot be estab-
lished.
Your Bluetooth
®
devices may not be
compatible.
Check the settings on your
Bluetooth
®
device.
Bluetooth
®
transmis-
sion is not activated on
your playback device.
Switch on Bluetooth
®
trans-
mission on your playback
device. Please refer to its
operating manual for more
information.
The distance between
the headphones and the
playback device is too
great.
Ensure that the headphones
is no more than 10 metres
away from the playback
device.
You hear no
sound in your
headphones.
The playback device is
not switched on.
Switch on the playback
device.
The volume control of
the playback device
is set to the minimum
volume.
Increase the volume at the
playback device.
Sound is only
coming from
one side of the
headphones.
The stereo balance
control on the playback
device is incorrectly
adjusted.
Adjust it to the setting you
desire.

Silvercrest SKBA 2 A1 Specifications

General

Brand	Silvercrest
Model	SKBA 2 A1
Category	Headphone
Language	English