Silvercrest SLE 200 A1 - Programme Selection; Selecting Programmes

GB
│
IE
│
13 ■
SLE 200 A1
Selecting programmes
The appliance has 2 programmes:
▯ DEHUMIDIFICATION (
)
▯ FAN (
)
♦ Press the

button t repeatedly to select the desired programme. The
selected programme flashes for approx. 5 seconds and is then shown
permanently on the displayw.
DEHUMIDIFICATION
This programme allows you to set the desired relative air humidity level that
should be achieved.
♦ Press the buttonr to set the desired relative humidity in 5% increments
between 30% and 80%. The set value flashes for approx. 5 seconds on the
display w and then the current programme ( ) is shown again.
You also have the option to select the
setting if you want to set the relative
humidity below 30%. This setting allows you to achieve a very low relative
humidity as the dehumidification runs permanently.
♦ Press the buttonr repeatedly until is shown on the displayw.
NOTE
► Note that the values for the relative humidity have a tolerance of approx.±3%
and that there may be a slight delay before the appliance itself/the de-
humidification function switches on or off.
► The minimum humidity that can be achieved in continuous dehumidification
mode (
) is dependent on many factors, such as the room size or the
ambient temperature, etc. Therefore, it is not possible to define a generally
applicable minimum value.
FAN
No dehumidification takes place in this programme. The room air is drawn in
through the air inlet3, passes through the filter5 and is discharged back into
the room through the air outlet7.
Select this programme if you want to circulate but not dehumidify the air in the
room.