Silvercrest SLE 200 A1 - Operation Features; Timer Function; Emptying the Water Tank

■ 14
│
GB
│
IE
SLE 200 A1
Timer function
The appliance is equipped with a timer function that can be used with either of
the programmes. Switch-off times, ranging from 1 to 12 hours, can be selected.
Once the set time has elapsed, the appliance switches off permanently.
♦ While the appliance is running, press the
buttone repeatedly to set a
switch-off time between 1 and 12 hours. The selected switch-off time flashes
for approx. 5 seconds on the display w and then the current programme is
shown again. Additionally, a point appears on the right of the displayw,
above the
symbol. This indicates that the timer function has been activated.
♦ To end the timer prematurely, press either the
buttone repeatedly
until appears on the displayw or switch off the appliance with the
buttonz.
Emptying the water tank
The water tank6 has a capacity of approx.2.2litres. When the water tank6
is full, the appliance will beep for approx. 20 seconds and will appear on the
displayw. The dehumidification stops, the fan continues to run for approx. 3 minutes
and then switches off.
♦ Pull the water tank6 carefully out of the appliance using the grips on the
side (see figure 1).
6
Fig. 1
♦ Tip out the water and replace the water tank6 into the appliance. The
appliance resumes operation with the previously selected programme after
around 3 minutes.