GB
│
IE
│
NI
│
9 ■
SLS 3 A1
Long-hair trimmer attachment
If you do not want to completely shave off the hair or
merely want to trim your bikini line, use the long-hair
trimmer attachment w.
1) Push the long-hair trimmer attachment w onto the
shaver unit 2 and press it down so that the long-hair
trimmer attachment w clicks into place. Ensure that the
open grooves lie over the trimmer 1.
2) Press the travel lock and push the on/off switch 5
in the direction of the shaver unit 2. The appliance
starts.
3) Move the appliance with straight motions over the
skin. Apply repeatedly and guide the shaver against
the direction of hair growth.
4) After you have covered all the areas you want to
shave, push the on/off switch 5 back into its initial
position. The appliance stops.
5) Clean the long-hair trimmer attachment w with the
supplied cleaning brush 9. For a more thorough
cleaning, read the section “Cleaning, care and
maintenance”.
Cleaning, care and maintenance
CAUTION! MATERIAL DAMAGE!
► Do not use abrasive, chemical or caustic cleaning
agents to clean this appliance. This will irreparably
damage the appliance.
NOTE
► As soon as the shave becomes noticeably worse, we
recommend replacing the shaver unit 2.
To order a new shaver unit 2, please contact the
service department (see section “Ordering replace-
ment parts”). Have the IAN number of the item to
hand. You will find this on the front page of these
operating instructions or in the section “Service”.
To Next Page
Loading...
