GB
│
IE
│
NI
│
11 ■
SLS 3 A1
Cleaning under running water
1) Press the two release buttons 4 and pull the shaver
unit 2 upwards off the appliance.
2) Hold the shaving head 3 under running water.
Make sure that you hold the appliance so that the
shaving head 3 is angled downwards. This allows
the water to drain off and prevents it from getting into
the appliance.
CAUTION! MATERIAL DAMAGE!
Hold only the shaving head 3 under running water.
The shaver handset can be damaged irreparably if it
is held under running water.
3) Allow the shaving head 3 to dry.
4) Replace the shaver unit 2 on the shaver. Ensure that
it snaps into place and is seated firmly.
Storage
■ Always replace the long-hair trimmer attachment w
onto the shaver unit 2 when you are not using the
appliance. This protects the shaver unit 2.
■ Store the cleaned and dried appliance and its
accessories in the supplied storage bag q.
■ Store everything in a clean, dust-free and dry place.
To Next Page