GB
│
IE
│
NI
│
CY
│
9 ■
SMS 300 A1
Operation
WARNING! RISK OF INJURY!
► Never look into the UV-C lamp
8 during use!
► Never use the appliance on people or animals! UV radiation can lead to
injuries to eyes and skin.
► Only operate the appliance when it has been properly assembled.
This is the only way to avoid the dangers of UV radiation.
► Use this appliance only as described in these operating instructions.
This is the only way to avoid the dangers of UV radiation.
NOTE
► Use the appliance only if it is completely and correctly assembled. The
dust container
3 and the dust filter 4 must be inserted correctly and
undamaged. If dirt gets into the motor of the unit, it could cause motor
damage.
► Make sure that the safety switches of the UV-C lamp
8 on the underside
of the appliance are not blocked.
► Test the appliance on a small, unobtrusive spot first.
1) Plug the power plug into a properly installed, easily accessible wall outlet.
2) Place the appliance flat on the surface to be cleaned.
3) Press the On/Off switch
2 to turn on the appliance.
Make sure that the On/Off switch 2 fully engages.
The appliance starts vacuuming.
4) Press the vibration button
w to activate the vibration head 7. The vibration
shakes up the surface to be cleaned and the swirled up dust is sucked in
through the suction opening 9. Pressing the vibration button w also switches
on the UV-C lamp 8.
5) Move the appliance evenly over the surface to be cleaned.
6) After vacuuming, press the On/Off switch
2 to turn off the appliance.
7) Unplug the appliance from the mains socket.
To Next Page
Loading...
