Silvercrest SMS 300 A1 - Cleaning the Dust Filter

■ 12
│
GB
│
IE
│
NI
│
CY
SMS 300 A1
Cleaning the dust filter
♦ After you have removed the dust filter 4 from the dust container 3, place
the dust filter 4 in a plastic bag. Close the plastic bag and knock the dust
filter 4 out carefully.
♦ Wait until the dust in the plastic bag has settled and then remove the dust
filter
4 from the plastic bag. Close the plastic bag again and dispose of it
afterwards.
♦ If necessary, you can rinse out the dust filter
4 with fresh cold or lukewarm
water. Allow the dust filter 4 to dry out completely.
♦ After cleaning, replace the dust filter
4 in the dust container 3 so that it is
firmly seated.
♦ Replace the empty dust container
3 with the inserted dust filter 4 in the
recess for the dust container 3 on the appliance.
NOTE
► New dust filters
4 can be reordered from the customer service
(see section Ordering spare parts).
Cleaning the UV-C lamp
WARNING! RISK OF INJURY!
► The UV-C lamp
8 gets hot during use. Allow the UV-C lamp 8 to cool
down sufficiently after use. Otherwise, there is a risk of burns.
♦ Use a screwdriver to loosen the screw on the cover
e of the UV-C lamp 8
and remove the cover e.
♦ Wipe the UV-C lamp
8 with a dry duster.
NOTE
♦ Be careful not to touch the UV-C lamp
8 with your fingers.
♦ Put on the cover
e and fix it again with the screw.