Silvercrest SOR 2400 D2 - Product Functions; Switch Off the Product; Frost Protection Function; Use the Heating Fan Only

12 GB
 Press the heating fan switch
4
to position
“I” to switch on the heating fan. An indicator
in the heating fan switch
4
will light up.
Hot air will be blown through the hot air
outlet
5
.
 To switch off the hot air outlet
5
, press the
heating fan switch
4
to “0” position.
 Using the temperature control
3
to set the
product to the desired temperature.
 Switch off the product
 Press the heating fan switch
4
to position “0”
to switch off the hot air outlet
5
.
 Turn the temperature control
3
to MIN and
the heat level switch
2
to “0”.
 Remove the mains plug from the mains
socket.
 Frost protection function
The frost protection function
automatically controls the product to
keep the room temperature above
7°C, steps are as follows:
 Connect the product to an earthed mains
socket protected by a residual current circuit
breaker.
 Switch on the product by setting the heat
level switch
2
to either “1”, “2” or “3” and
by setting the temperature control
3
to
“MIN”. The product switches on when the
room temperature is approx. 7°C. As soon
as the room temperature is above 7°C, the
product automatically switches off again.
Note: The product will switch itself on and
off automatically to maintain a temperature
higher than 7°C.
 Use the heating fan only
To use the hot air outlet
5
only on the
product, steps are as follows.
 Connect the product to an earthed mains
socket protected by a residual current circuit
breaker.
 Press the heating fan switch
4
to position
“I” to switch on the hot air outlet
5
. An
indicator in the heating fan switch
4
will
light up. Hot air will be blown through the hot
air outlet
5
.
 To switch off the hot air outlet
5
, press the
heating fan switch
4
to “0” position.
 Care and cleaning
WARNING! Let the product to cool down
before cleaning.
WARNING! Never immerse the product,
power cord or mains plug into water.
 Remove the mains plug from the mains socket
and leave the product to cool completely
before cleaning.
 Use a damp lint-free cloth to clean the
product. Use a mild detergent on the cloth
for stubborn dirt.
 Do not use abrasive, aggressive or chemical
cleaning agents. It could damage the surfaces
of the product.
 Storage
 If the product not to be use for a long period
of time, clean it as described in the section
“Care and cleaning”.
321301_SI_CZ_SK_02.indb 12 17/5/2019 3:40 PM