Silvercrest SPS 3 A1 - Setting up; Package Contents and Transport Inspection

■ 46
│
GB
│
MT
SPS 3 A1
■ If liquid penetrates the device, switch it off, disconnect it from
the power supply and have it inspected by qualified special-
ists before using it again.
■ If the device is moved from cold to warm surroundings, wait
for approx. 2 hours until the device has reached the ambient
temperature before switching it on.
■ If you are using a USB power supply, the mains socket used
must always be easily accessible so that the USB power
supply can be quickly disconnected from the socket in a
hazardous situation. You should also observe the operating
instructions for the USB power supply.
■ If you notice a burning smell or smoke coming from your
device, unplug all connections immediately.
Setting up
Package contents and transport inspection
(See fold-out page for illustrations)
DANGER
► Do not allow children to play with packaging materials.
There is a risk of suffocation.
♦ Remove all parts of the device and the operating instruc-
tions from the carton.
♦ Remove all packaging materials from the device.
Check the contents of the package. The following components
are included in delivery:
▯ Soundbar SPS 3 A1
▯ Cable adapter (3.5 mm Ø jack socket to stereo RCA plug)
▯ These operating instructions
NOTE
► Check the package for completeness and signs of visible
damage.
► If the delivery is incomplete or damage has occurred as a
result of defective packaging or during transport, contact
the Service hotline (see section Service).
IB_339086_SPS3A1_LB5.indb 46 16.01.20 17:00